Embroidered fabric wholesale India offers a wide range, from fine hand work to machine embroidery in long rolls. To buy well you need to know the technique, the base fabric and the signs of good stitching.
This guide explains the common embroidery types, the base fabrics they sit on and a short checklist for judging quality.
Common embroidery types
These names describe the technique. A single piece can combine several, such as thread work with sequins.
- Zari: metallic thread, traditional or imitation, used on sarees, lehengas and suits.
- Resham (thread work): silk or polyester thread in colour, giving a softer look than zari.
- Schiffli (hakoba): machine embroidery with fine, repeating patterns, common on cotton, georgette and net. Hakoba is a style often seen on cotton.
- Sequin: flat discs attached in rows or motifs, used for party and festive wear.
- Mirror work: small mirrors held by stitches, from Gujarat and Rajasthan traditions.
- Chikankari: white-on-white or tonal thread work from Lucknow, done by hand or imitated by machine. See chikankari kurtis.
Base fabrics
The base controls how heavy the piece is and how it wears. Light fabrics need fine, flat embroidery, while heavier work needs a stronger base.
Common bases include georgette, net, chiffon, organza, cotton, velvet and silk. Browse everything on our embroidered fabrics page.
Matching base and technique
Some pairings work better than others.
| Base | Works well with | Watch for |
|---|---|---|
| Net | Sequin, thread work, zari | Snagging, needs lining |
| Georgette | Resham, sequin, schiffli | Puckering if base is too thin |
| Cotton | Schiffli, chikankari, thread work | Shrinkage of base |
| Velvet | Zari, dabka, heavy thread work | Weight, pile marks |
| Organza | Fine thread work, cutwork | Stiffness, fraying |
How to judge embroidery quality
Look at the piece flat, then from the back, then under light.
- Density and evenness: motifs should be the same size and spacing along the roll.
- Thread quality: thread should be smooth, with no fuzz, and colour should match across the repeat.
- Back of the fabric: loose threads, knots and uncut ends show poor finishing.
- Puckering: the base should lie flat, not pull around the stitching.
- Secure sequins and beads: tug gently and check that they stay attached.
Colour, wash and care
Metallic zari can tarnish and some dyed threads can bleed, so ask whether the fabric is dry-clean only. Test a small piece for colour fastness before you put it into stitched garments.
See our fabric quality checklist for width, shrinkage and lot checks. Embroidery repeats can vary between lots, so approve a sample and keep it for comparison.
Ordering embroidered fabric and finished suits
Fabric is usually sold by the metre or in a set of lengths. Ask for the width, the embroidery width on the roll and the minimum length per design. The minimum depends on the design.
If you want finished garments, see embroidered salwar kameez and embroidery kurtis.
Frequently asked questions
What is the difference between schiffli and hakoba?
Schiffli is a machine embroidery method that produces fine, repeating patterns. Hakoba is a style often seen on cotton, usually made by that kind of machine work.
Is chikankari always handmade?
No. Traditional chikankari is hand embroidered, but machine versions exist at lower prices. Ask which one you are being quoted.
Can I get a sample metre?
Yes, samples are chargeable (sample cost plus courier). Prices are shared on request.
Ready to source?
Send the embroidery type, base fabric and quantity you want through the [contact](contact) page and we will send a quotation.
